Dwin TransVision 3 Enhanced Instruções de Operação descarregar pdf (Página 31)

2D. Connecting the TransVision

™

3E System

Connect the AC Power Cord to the projector and connect it to an unswitched

AC outlet. Connect the projector to the TransVision

™

3E Processor using the

circular connector of the DVI cable.

A. The AC power receptacle should be connected to a non-switched 120 VAC

outlet using the power cord provided with the TransVision

™

3E system.

B. The IR Sensor points toward the screen so that IR commands sent by the

remote control are received by the system. To insure proper operation, this

sensor should not be covered.

C. NOTE: The TransVision

™

3E requires the use of a DWIN DVI cable between

the Projector and the Digital Video Processor to operate correctly !

D. The POWER LED is a multi-purpose indicator:

• When the LED is dark the AC power to the unit is turned off.

• When the LED is ﬂashing on and off, power is connected and the unit

is in the standby mode.

• When the LED is on the unit is powered on.

• When the LED is ﬂashing fast, the projector lamp failed to ignite. The

lamp may have failed or overheated. In case the lamp is hot, wait ap

proximately 1 minute to turn the unit on. If the lamp has failed, contact

your DWIN dealer or DWIN for a replacement.

120 VACDigital Input

ansVision

™

IR Sensor

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38 39

Sem comentários

Dwin TransVision 3 Enhanced Instruções de Operação Página 31